J1772 cable extender for EV charging 32A 20ft

EV charging cable extender for your electric vehicle (EV/PHEV). With this cord, you can extend your existing SAE J1772 charging cable to reach 20 ft longer. Compatible with all J1772 charging cables. The cable is 32 A, 1-phase, and charges your EV with up to 7.2kW of power. The product has a nice appearance, a hand-held ergonomic design, is easy to use, and is made from thermoplastic material. It has a protection level of IP44 and is anti-flaming, pressure-resistant, abrasion-resistant, and impact resistant.

How to use:

We recommend using the following steps:

1. Plug in the J1772 male end of the cable to the charging cable to extend it
2. Plug in the J1772 female end of the cable to the car’s charging socket
3. After the cable has clicked in place, you are ready for the charge*

*Don’t forget to activate the charging station according to the instructions

When you finish with the charge, always disconnect the vehicle side first and then the charging station side. Remove the cable from the charging station when not in use.

How to store:

The charging cable is the lifeline of your electric vehicle, and it is essential to keep it protected. Store the cable in a dry place, preferably a storage bag. Moisture in the contacts will result in the cable not working. Suppose this happens place the cable in a warm and dry place for 24 hours. Avoid leaving the cable outside where the sun, wind, dust, and rain can get to it. Dust and dirt will result in the cable not charging. For longevity, ensure that your charging cable is not twisted or excessively bent during storage.

The J1772 cable extender for EV charging 32 A 20 ft is very easy to use and store. The cable is designed for both outdoor and indoor charging, and it has IP44 (Ingress Protection). Therefore, this means that it has protection from dust and splash of water from any direction.